How to make your own custom Navy Seal copypastas

You can print out this awesome copypaste of your own Navy Seal seal copyset, or you can grab a copy of the PDF file here.

The first thing you need to do is grab some basic scissors and some scissors and a pair of pliers.

Then, cut your seal copy into strips.

For this copypasted one, you need 2 1/2″ x 3 1/4″ strips of fabric that measure 1″ x 2″.

For your sealer copypaster, you can make it a little bigger and a little thinner.

For the sealer version, you want the fabric to measure 4″ x 5″.

Make sure you buy the right type of sealer because if you get a plastic sealer instead of a polyester one, the sealant will break down, causing the seal to leak.

To cut out your sealcopypasta strips, fold the top and bottom strips over in half and cut them.

Then fold them in half again and cut out the sides of the strips.

Now that you’ve cut the strips, you should have about 1″ of fabric on each side of the piece.

You can leave some slack to make sure you get the proper seal.

Now you need two of the pliers to hold the seal copyer in place.

Then you need a flat knife to pry the seal from the fabric.

Then take your pliers and pull the seal out.

You should have a long strip of fabric.

Now cut a long piece of fabric from that fabric and place it on top of your seal.

Then trim down to about 1 1/3″ in length and make sure to make a slit in the center.

The end of the slit should be about 3/8″ from the edge of the seal.

Next, cut a piece of masking tape.

Now, cut out a piece that is about 1/8-inch in diameter.

You want the masking piece to be about 1 inch wide.

Now fold the fabric over in the middle of the seam, making sure to fold all the way around the seam.

Then cut a hole through the fabric at the bottom of the mask.

You’re done.

Now take your plastic seal copying scissors and cut a slit right through the plastic.

Now use the plier to pierce the seal at the slit.

Make sure to be precise and do not cut through the mask when the seal is still attached to the seal, because the mask will shrink over time.

Now slide the mask into the plastic and seal it.

You now have a perfect seal.

You might want to cut out some decorative embellishments to give the seal a little extra flair.

Next time, you’ll be able to get more fancy with your custom seal copymaster, and hopefully you’ll have some new friends to tell you about.